The Essentials of – Revisited

Helpful Hints for Replacing a Cutlass Bearing

The bearing found on a vessel’s drive shaft log that is made with brass and a rubber lining that is grooved from the inside and which is lubricated by the water around that enters the grooves on rotation is what is termed as cutlass bearing, this.

It does not matter the number of times that you use your boat, but you must at some point change the cutlass bearing. When it is time to change that cutlass bearing, you will find the cutlass bearing a bit far from the keel or somewhere buried in the woodwork of the boat.

Apart from getting your hands dirty, you will not face any challenges when removing the cutlass bearing. Keep reading this article to know how to replace a cutlass bearing, now.

Locating and removing the set screws should be the first thing to do. In several cases, the set screws will be found hidden below the layer of growth and crud. Not all boat manufacturers use the set screws. If you already know that your boat does not have set screws, then it is not good to waste time looking for them.

Cutting the bearing is a must in the replacement of the cutlass bearing. You can cut the cutlass bearing using a hacksaw if you don’t have a Sawzall from Propeller Depot with you. You must have enough knowledge of how to use the Sawzall tool from Propeller Depot.

Now to remove the cutlass bearing by bending it. Using a cold chisel and a hammer it is possible to bend the cutlass bearing to the inner side so that you get to the place where you have made the cut. If you want to bend the cutlass bearing avoid using a lot of force by hitting it. When you forcefully bend the cutlass bearing, you risk damaging the strut of the boat.

To open the cutlass bearing up to the other end, do so by putting a maple dowel after creating a space by bending the boat’s cutlass using a hammer. Do not use metal tools to slit open the cutlass bearing up to its length. If you do so, you risk damaging the inside of the strut.

Lastly, you can now remove the cutlass bearing. Do this with a pair of pliers to hold and remove the bearing. Install a new cutlass bearing after you clean the strut’s surface. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.

You will damage the strut’s ramrod if you push it and the line it is not straight. So that the ramrod of the strut can go in straight use some grease on the cutlass bearing to help it to slide in easily.